If you receive a prompt that the gateway or DNS is invalid, enter the following values: Now refresh the settings by clicking device read to verify that the sign saved your new settings. Uncheck DHCP if checked -Change the IP address to 10.1.10.128 -Enter the Subnet mask 255.255.255.0 Modify the settings for Wired Network.Click the Control tab at the top and then select Network Configuration.If the icon is orange, click connect and enter username admin and password 123456. Orange means you are connected but not logged in. Green means you are connected and logged in.Confirm that the player is listed and verify the activity status icon on the left.Open Viplex Express, select Async and select the terminal tab.Connect to the network and enter the password 12345678.Stand very close to the sign and search for the WIFI network called AP# (AP followed by a series of numbers).And have a laptop with Viplex Express installed. To access this network, you must be very close to the sign. Still unable to connect? If the settings above do not work, connect to the sign's backup network to check the network configurations.To attempt this route, contact us to schedule your session. Finally, the Access Point can also be reconfigured as a repeater to extend your Network to the sign.In other cases, we must reconfigure the Access point and Client to match your network settings An alternative option is to connect the LAN Port to your router.Leave the remaining fields blank then, select Ok, and then close.Now, select 'Use the following IP address, then enter the following IP address: 10.1.10.127.Right-click on your Ethernet Adapter and select properties.Select Network and sharing center and then change adapter options.Connect the computer to the Signcity network, then proceed to the next step.To maintain the best connection, position the Access point and Client within the line of sight of each device. Three (3) lights indicate that you have an excellent connection to the access point.The three lights above display the signal strength. You may notice that the LAN light intermittently flashes. The first two lights, Power and Lan, should be constantly lit.You can verify that you have a good connection by looking at the lights on the Client. Wait for the access point to power on, and all the lights are lit.To power the Access point, plug the ethernet cable into the POE port on the POE injection. Use the provided POE injector to connect the power to the access point.Connecting wirelessly: Connect the Client to the antenna port on the sign.When using the access point and Client together, you can connect wirelessly over Wi-Fi or directly with the provided LAN/Ethernet cables. Using the Client and the Access point together extends the Network and lets you connect over a further distance. After you connect, open the Viplex Express and move to the next step.Open your Wi-Fi settings and connect to the Signcity network (enter password above).To use this method, connect the Access Point to your sign and wait for all lights on the side to be lit. The local Network is called ' Signcity' out of the box, and the password is Signcity123. The access point will create a local network. Using just the access point is possible if your office is close to the sign. There are two ways to connect your computer to the sign using the CPE antennas. The CPE antenna creates a local network that you can use to connect to your sign. Below are the steps for connecting with the CPEs or optional 4G modem. You may have two CPE antennas, a Client, and Access Point, depending on your selections.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |